Super Big Bore with 7.28" bore thru spindle, Live milling, Y axis, 50 HP, Schunk Rota TB2 470-185 3-jaw air chuck, Live quill tail stock, Programmable Driven tail stock, Like new with only 768 Cut Hours.
|Max RPM||1,400 RPM|
|Dimensions||165" x 94.09" x 99.29"|
ONE LIKE NEW SUPER BIG BORE OKUMA CNC LATHE WITH LIVE TOOLS and Y AXIS Model: LB4000EXII-MY-1SC-SBB-1500MM Swing over way covers: 26.38” Swing over saddle: 18.90” Max. turning diameter: 16.93” Max. work length: 59.05” X travel: 11.81” Z travel: 62.60” Y axis travels: +2.76”/ -2.76” C axis: .001 degrees 12 position turret, with 1” square wedge clamp O.D. tool capacity Rapid traverse rates: Z, X, Y: 1,181 ipm, 984 ipm, 492 ipm Spindle bore: 7.28” Spindle speeds: 12-1,400 rpm Spindle HP: 50/40 VAC motor, direct belt drive Spindle torque: 258 lbs/ft. Spindle nose: A2-15 Max. spindle part weight: 1,760 lbs. with or w/o tail stock Live milling: 10/5.8 HP, 45-6,000 rpm with ER40 taper, including: Synchronized tapping, timing gears permit re-tapping, Flex cycles for end face and OD cutting, cutter comp, repeat function, X-Y plane conversion, C-X contour generation. Tail stock taper: #5 MT Dimensions: 164.5” x 94.09” x 99.29” high x 18,920 lbs. EQUIPPED WITH: Schunk Rota Md. TB2 470-185 3-jaw air chuck OSP-P300LA controls with AOT (Advanced One Touch) Integrated Graphics Function Conversational programming system with Tool Data and Simulation Portable Pulse Handle Rapid traverse override switch Variable speed threading Negative Tool Radius comp Thread Start Point Offset Feed Hold during threading Off center turning function 4-sets of Spare M-codes Spindle extreme low speed cutting function Spindle orientation, electric type Manual Touch setter MP Systems UL300 medium pressure Coolant pump Live Quill tail stock Programmable ball screw “Driven” tail stock Velocity Static tool holder kit: 3) OD-1 Holders, 1) OD-II holder, 2) Boring bar holders (1.5” ID) Velocity Live tool holder kit: 2) End face mill/drill units (ER40 EXT. coolant), 2) Side face mill/drill units (ER40 EXT. Coolant). LNS Hinge type chip conveyor Head stock cooling system Head stock mounting surfaces are hand scraped Hardened and ground boxed ways on X, Y, & Z New: November 2018 Total Cutting Hours: 768 The above is subject to prior sale and verification by buyer. Specifications and age herein are assumed correct but are not binding in detail. Ask for terms and conditions of sale if not attached.